Before you entrust your belongings to a new tailor, I can't stress this enough - ask to look through their work done (aka other people's stuff hanging on the racks waiting to be picked up). Be on the lookout for signs of good versus shoddy work. Some tips below that I wish I knew a year ago ...
1. Alteration Type: Basic Hem
Signs of shoddiness: Pulling of fabric from incorrect stitch type or incorrect stitch tension, crooked and uneven spacing.
Here's a trench coat I had shortened. Not only was it hemmed inches too short, but the hem was very sloppy! The thread tension was way too tight and pulled on the fabric. Also, on trench coats the bottom hem is usually a wide one (1 to 1.5 inches). Any good tailor would have redone this without being asked:
Signs of a good job: Even spacing throughout hem, symmetrical, correct stitch type and spacing (ie: suiting and dress pants require the invisible stitch done by hand).
To compare with the above, here is the original hem on a trench coat. One may say it's kind of cheating to compare with an original, but any good hem job should look just like the original!
2. Alteration Type: Take in waist
There's usually 2 ways to go about this... 1. one incision done via the back center of the waist, or 2. two incisions on both sides of the waist. If you need a lot taken in (I'd say anything over .5 to 1 inch), the latter method should definitely be used or else the fit and proportions will be messed up. If the tailor suggests otherwise ... go elsewhere!
Signs of shoddiness: This is a pair of Banana Republic Martin pants, size 0 (this must have been before I knew they made 00). I needed a good 1.5 inches taken in, yet the tailor insisted on doing it the first method!
Sloppy stitching, lining looks messy, Banana Republic size / care tags nowhere to be found:
Alteration is very visible from the outside via the poor stitching, pockets super close together:
Bad waist alteration on dress pants, exterior
Yeeks! 3 belt loops so close together looks bad (fixable), pockets too close together forming a weird angle on the butt (not fixable).
Yeeks! 3 belt loops so close together looks bad (fixable), pockets too close together forming a weird angle on the butt (not fixable).
Also, this is not evident via the pics, but she made the waist so small that I could barely pull these pants over my hipbones. Bye-bye $80 pants and $20 for alterations. I'm too much of a sucker to ask for my money back.
Theory pants, size 00. Needed only half an inch taken in, so my tailors at Hemmingway said it was best via the back center. Note the clean lines showing perfect reattachment of waistband. The weird darts on both sides were there when I bought the pants.
Clean and symmetrical reattachment. Now that I look at this closely, I just noticed that the Theory label is missing, just like the bad BR waist job above! Grr...make sure to tell your tailor if you want to keep the size/brand label.
The second pair are Express pants, size 0 Short. These were huge and needed 2 inches taken in. Both sides of the waist method was the way to go.
Note the clean reattachment from the inside of the waistband:
Note the clean lines and angles from the outside. The fit was perfect and you can't tell at all that so much was taken off:
I just realized neither of my "good" examples are lined. Will have to hunt for a better example : )
3. Alteration Type: Working with silk.
I love silk, but it definitely requires special treatment when being altered. The needle and thread used must be thin, or it will pull on the fine silk. Silk textures vary, so it's important that the tailor knows what he or she is doing. Make sure you ask exactly what they plan on doing.
Signs of shoddiness: pulling and damage on the silk.
Just thinking about this incident breaks my heart! This is what my beautiful 100% silk Theory ombre blouse, size P used to look like:
It was just a tad too long, so I took it to a tailor to get it hemmed 2 inches. She said no problem. When I got it back, however, I was appalled to find that she had done a crooked, super wide (1.5 inch) hem by hand. The needle used was probably thick, because each stitch showed clearly and pulled on the silk, leaving behind long streaks of damage. I don't have a photo of my blouse in this sad state.
Signs of a good job: thin, even, rolled hem with delicate stitching.
When I took it to Hemmingway for repairs, the ladies were equally horrified. They said the silk on the bottom 1.5 inches was so pulled and damaged (not to mention crooked) that it had to be cut off. They re-did the hem, shown below:
But now look at my poor blouse! Although the hem job was redone correctly, the blouse is now several inches too short for me. I can only wear it under blazers and have to consciously avoid raising my arms to prevent giving anyone a peek show.
