The guide below is based on the design above. However, it is pretty fleaxible for you to mix and match with other beads based on your preference.
Materias required:
16 gauge copper wires (thick wires) to form the frame.
26 gauge copper wires (thin wires)
16 x 0.8cm rounds beads
8 x 1.5cm round beads
1. Cut 4 pieces of 16 gauge thick wires approximately 12 inches in length.
2. Cut approximaly 25 inch of 26 gauge think wires. Attach the thin wires around the thick wires 4 times.
3. Thread in a 0.8cm of round bead and place it next the to thick wires.
4. Place the second thick wires next to the round bead at the other end. Wrap the thin wires around the thick wires to secure the position.
5. You may like to push the beads towards to right hand side of the bangle. It is easier for you to wrap the thin wires against the thick wires for the subsequent steps.
6. Now thread in the 1.5cm round bead and place it next to the second thick wires.
7. Place the the third thick wires and wrap the thin wires around the tick wires for 8 times.
8. Now, thread in the next 0.8cm bead and park it next the third wires.
9. Then place the fourth thick wires next the the small bead and tie the thin wires for 8 times.
Hope you will be able to follow so far. Watch out for the next post for the subsequent steps.
If you prefer to read the full tutorial in pdf format, you can get it from the link here.
Download lots of free jewelry making tutorials at DiyLessons! Are you a jewelry (jewellery) making teacher/ tutor? You can also list your tutorials here too.Don't miss a post! Subscribe to Handmade Jewelry Club by Email FREEFind the website useful? You can easily link us using the codes below by just copy and paste them into your blog or website. You can also include the codes in your email and recommend it to your friends!
